Common problems of diversion nozzle and leakage nozzle for gas atomization pulverizing
Release time:
2024-07-05
The guide nozzle for gas atomization powder is an important part of spray powder equipment, but the problem of leakage nozzle will affect the quality of powder and production efficiency. This paper will discuss the common problems and solutions.
1. Leakage phenomenon: During use, the diversion nozzle may leak, causing material waste and low production efficiency.
2. Leakage reason: Leakage may be caused by dust mouth wear, lax sealing or long use time.
3. Solution: Once the problem of leakage is found, timely measures should be taken. Leakage caused by wear or aging can be solved by replacing the new guide nozzle. At the same time, regularly check the seal of the guide nozzle to ensure good sealing performance.
4. Maintenance: Clean the diversion nozzle regularly to avoid accumulation of dust and impurities. Maintaining the finish of the nozzle surface can extend service life and reduce the chance of leakage problems.
In general, the problem of leakage of the guide nozzle for gas atomization pulverizing can be avoided and solved. As long as you pay attention to maintenance and maintenance, and deal with problems in time, you can ensure the normal operation and high-quality production of pulverizing equipment.
Related information
QR code
Fuzhou Ceravite New Materials Development Co.,Ltd.
Add:691 Dongtian Village, Yangxia Street, Fuqing City, Fuzhou City, Liandong U Valley·
Building 13 and 15 of Fuqing Rongqiao Economic and Technological Development Center
Tel：86-13799982018 （Mr. Chen）
E-mail: ccb@ceravite.com.cn
Tel: 86-0591-83709236
Fax: 86-0591-83709236